1.6.3 Bug: “Track to here” disappear after “Record Track”

Home All Topics General 1.6.3 Bug: “Track to here” disappear after “Record Track”

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #4151
    • Topics: 19
    • Replies: 38

    Here is the procedure:

    1. Select any POI/Waypoint and “Track to Here”
    The app will now draw a line from current location to the selected POI/Waypoint

    2. After several seconds, “Record Track”
    The app will start to record Track by drawing a line from previous position to current position.
    At this point, the “Track To Here” line disappears.

    If I were to reverse the process, or perform step #1 again, that line is redisplayed again.

    I believe this is a bug. That “Track to Here” line should not disappear. It should be visible until explicitly removed by the user.

    • Topics: 32
    • Replies: 799

    This isn’t a bug per se, but rather the current interface is a bit clunky.  You can have multiple Waypoints and multiple Recordings on a single Track, but only 1 thing may be selected at a time. After you start a recording, you can roll the wheel on the left side of the track info panel to re-select the waypoint you want displayed.

    This will be improved in the next major update to show you info about both the current recording and the current waypoint.
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Geomagik LLC

Contact Us

If you have any questions, comments or suggestions, we'd love to hear them!
Please fill out the form below or post to our Forum.

    PocketEarth © 2012 GeoMagik LLC. All rights reserved. Apple, the Apple logo, iPod, and iTunes are trademarks of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc.